To make a Christmas tree skirt, you cut a large fabric circle with a small hole in the middle and a straight opening from the edge to the centre, line it, and add ties so it can wrap round the base of the tree. For a standard 6ft tree, a skirt 100cm across is the usual size. It takes about 1.1m of 112cm wide cotton for the top and the same again for the lining, and about two to three hours to sew. This guide covers which size to make for your tree, how much fabric you need, how to draw a perfect circle without a pattern, a lined method step by step, a patchwork version from fat quarters and a no-sew fleece version.
A tree skirt hides the stand, catches falling needles and gives the presents somewhere to sit. It is also one of the few Christmas makes you see every day for a month. Our Christmas fabrics are 112cm (45in) wide printed cotton at £3.50 a metre, and every amount below is worked out for that width unless it says otherwise.
What size tree skirt do you need?
Measure the spread of the lowest branches and make the skirt a little smaller, so it sits just inside them and shows round the edge. As a rule of thumb, the finished diameter should be about half the height of the tree.
| Tree height | Finished diameter | Cut circle (radius) | Fabric per layer, 112cm wide | Fabric per layer, 140cm wide |
|---|---|---|---|---|
| Up to 4ft (120cm), or a tabletop tree | 75cm | 38.5cm | 0.8m | 0.8m |
| 5ft to 6ft (150cm to 180cm) | 100cm | 51cm | 1.1m | 1.1m |
| 7ft (210cm) and taller | 120cm | 61cm | 2.5m (two half circles, joined) | 1.3m |
The cut radius is half the finished diameter plus a 1cm seam allowance. A lined skirt needs two layers, so double the fabric: a standard 100cm skirt takes 1.1m for the top and 1.1m for the lining. The centre hole is 12cm across when finished, which fits round the trunk and most stands; make it bigger if your tree sits in a wide metal or water-filled stand.
The large size is the one place where width matters. A 122cm circle will not fit across 112cm fabric, so either cut it as two half circles and join them with a seam, or use a 140cm (55in) wide fabric such as our furnishing fabrics, which fit the whole circle in 1.3m. For more on how width changes the amount you buy, the UK fabric quantity guide works through it project by project.
The best fabric for a tree skirt
| Fabric | Look | Things to know |
|---|---|---|
| Printed Christmas cotton | Bright and festive | The easiest to sew and press, and washable. Add wadding if you want it to lie flat and look padded. |
| Velvet | Rich and traditional | Heavy and drapes beautifully. It has a pile, so cut every piece the same way up, press from the back and use clips rather than pins. |
| Tartan | Classic, cosy | Looks good with a plain red or cream lining. There is no need to match the checks on a single circle. |
| Polycotton | Plain colours | Cheap, light and creases less than cotton. A good choice for the lining. |
| Fleece | Soft and casual | Does not fray, so it can be left with a raw or fringed edge for a no-sew skirt. |
| Hessian | Rustic | Frays a lot, so line it or fringe the edge. Sheds fibres onto the floor at first. |
A plush look is easy with our velvet, which comes in 3 metre pieces 140cm wide; one piece makes the top of even the largest skirt with fabric to spare. If velvet is new to you, the difference between velvet, velour and velveteen explains what to expect from each. For the lining, plain polycotton at £2.69 a metre comes in 20 colours.
What you need for a lined tree skirt
- Top fabric and lining: the amounts from the size table, one layer of each.
- Wadding (optional): one layer the same size, for a skirt that lies flat and looks padded. A 3 metre pack of 150gsm super soft wadding is 152cm wide, enough for two skirts of any size.
- Ties: six lengths of ribbon, each 30cm, or three pairs of fabric ties.
- Trim (optional): pompom trim, ric rac or lace for the outer edge. For a 100cm skirt you need about 3.3m.
- To draw the circle: a tape measure, a pencil or chalk, and a large clear floor or table.
- Basics: thread, pins or clips, sharp fabric scissors and an iron.
Gold ric rac trim or a mixed trim bundle finishes the edge, and narrow ribbon makes the ties. Wash and press the fabrics before you cut if you plan to wash the skirt later, because cotton and polycotton can shrink by different amounts; how to wash fabric properly explains what to do for each fibre.
How to draw a perfect circle without a pattern
You do not need a paper pattern. The easiest way is to fold the fabric into quarters and draw a quarter circle from the folded corner.
- Fold the fabric in half, then in half again, so you have four layers with one corner where both folds meet. That corner is the centre of the circle.
- Hold the end of a tape measure at the folded corner. Swing the tape in an arc, marking a dot every few centimetres at the cut radius, for example 51cm for a standard skirt. Join the dots into a smooth curve.
- Mark a small arc 5cm from the folded corner for the centre hole. After the 1cm seam allowance, this gives a finished hole 12cm across.
- Pin the layers together and cut along both curves through all four layers.
For the most accurate circle, tie a pencil to a piece of string and pin the other end at the corner, like a compass. A flexible dressmaker's tape measure does the same job. Cut the lining the same way, and the wadding if you are using it.
How to make a lined Christmas tree skirt, step by step
1. Cut the circles
Cut one circle from the top fabric, one from the lining and one from the wadding, using the quarter-fold method above.
2. Cut the opening
Fold each circle in half and press a crease. Cut along the crease from the outer edge to the centre hole, on one side only. This straight opening lets the skirt wrap round the tree after the tree is up.
3. Add the trim
If you are adding a trim to the outer edge, lay it on the right side of the top circle with the decorative edge pointing inwards and the straight edge level with the raw edge. Tack it in place within the seam allowance. Stop 2cm short of the opening at each end.
4. Add the ties
On the right side of the top circle, pin three ties along each straight edge of the opening, made from 30cm lengths of 6mm ribbon or folded fabric strips: one 5cm from the centre hole, one half way and one 5cm from the outer edge. The raw ends sit level with the fabric edge and the ties point inwards. Tack them in place.
5. Layer and pin
Lay the wadding flat, then the top circle on it right side up, then the lining right side down. Line up all the edges, including both sides of the opening and the centre hole, and pin or clip all round. Tuck the loose ends of the ties and trim into the middle so they do not get caught in the seam.
6. Sew all round
Sew with a 1cm seam all the way round the outer edge, down both straight edges of the opening and round the centre hole. Leave a gap of about 20cm along one straight edge for turning. Backstitch at both sides of the gap. Use a strong polyester thread in a colour to match the top; our haberdashery has assorted reels.
7. Clip the curves
Trim the wadding close to the stitching. Cut small notches into the seam allowance every 5cm round the outer edge, and snip into the seam allowance every 1.5cm round the centre hole, close to the stitches but not through them. Without this, the curves pucker when turned.
8. Turn and press
Turn the skirt right side out through the gap. Push the curves out smoothly with your fingers and press the edges flat from the lining side, so the seam sits right on the edge. Fold in the edges of the gap and slipstitch it closed, or close it with the topstitching in the next step.
9. Topstitch and finish
Topstitch all round about 1cm from the edge. If you used wadding, add a few rings of stitching at even distances from the centre, about 15cm apart, to stop the layers shifting in the wash. Wrap the skirt round the base of the tree and tie the ties in bows.
Plenty of pins or clips make the long curved seam much easier to control; the guide to sewing pins and their uses explains which to choose for each fabric. If you are using wadding for the first time, our guide to wadding, interfacing and stuffing covers the weights.
A patchwork tree skirt from fat quarters
A panelled skirt made of eight wedges uses fat quarters instead of yardage and gives a striking star or pinwheel effect. Each wedge is one eighth of the circle, so for a standard 100cm skirt every wedge fits on one fat quarter of about 50cm x 55cm.
- Make a template: on paper, draw a straight centre line 46cm long. At one end draw a 6cm line across it, centred. 42cm along the centre line, draw a 41cm line across it, centred. Join the ends of the two cross lines with straight sides, then draw a gentle curve from one end of the 41cm line to the other, passing through the far end of the centre line. These sizes include 1cm seam allowances.
- Cut: eight wedges from eight fat quarters, or two wedges from each of four prints for a repeating pattern.
- Sew: join the wedges side by side with 1cm seams, leaving the seam between the first and last wedge open as the opening. Press the seams open.
- Finish: use the patchwork circle as the top and cut a plain lining to match it, then follow steps 3 to 9 above.
A pair of 4-piece fat quarter bundles covers all eight wedges, or you can make your own fat quarter bundle to choose every print. There is more on sizes and cutting in what a fat quarter is.
A no-sew fleece tree skirt
Fleece does not fray, so it can be cut and used without hemming. Cut a single circle with the centre hole and opening as above, from fleece or another non-fraying fabric. For a fringed edge, cut strips 2cm wide and 8cm deep all round the outside. For a double-layer skirt in two colours, cut two circles, lay them together and knot each pair of fringe strips, as in a no-sew fleece blanket. Use the fleece itself for the ties: cut three 2cm-wide strips, 25cm long, and knot them through small slits on each side of the opening. It takes about an hour and needs only scissors and a tape measure.
How much does a tree skirt cost to make?
| Item | Amount for a 100cm skirt | Cost |
|---|---|---|
| Top | 1.1m Christmas cotton at £3.50 a metre | £3.85 |
| Lining | 1.1m plain polycotton at £2.69 a metre | £2.96 |
| Ties | 1.8m ribbon | From a £3 pack |
| Total without wadding or trim | About £10 |
Adding a pack of 150gsm wadding (£6.95) and a gold ric rac trim (£5) brings it to about £22, with most of both left over for other projects. A velvet skirt made from one 3 metre piece costs about £10 for the top. A shop-bought fabric tree skirt of the same size usually costs considerably more, and is rarely lined.
Matching Christmas decorations
Make the tree skirt in the same prints as your stockings and bunting and the room will look planned rather than collected. Our Christmas stocking guide and the guide to how to make bunting give the amounts for each. Offcuts from a tree skirt circle are a good size for mini stockings, crackers or tree decorations; fabric Christmas crackers use pieces just 32cm x 18cm. And if a tartan skirt is on your list, see 12 things to make with tartan fabric for more ways to use the rest of the cut.
Christmas tree skirt FAQs
How much fabric do I need for a Christmas tree skirt?
For a standard 100cm skirt for a 5ft to 6ft tree, you need 1.1m of 112cm wide fabric for the top and another 1.1m for the lining. A small 75cm skirt takes 0.8m per layer. A large 120cm skirt takes 1.3m per layer of 140cm wide fabric, or 2.5m per layer of 112cm fabric cut as two half circles.
What size should a Christmas tree skirt be?
Make the diameter about half the height of the tree, so the skirt sits just inside the lowest branches. That is about 75cm for a 4ft tree, 100cm for a 6ft tree and 120cm for a 7ft tree.
How do you make a tree skirt without a pattern?
Fold the fabric into quarters, hold a tape measure at the folded corner and mark an arc at the radius you want, plus 1cm for the seam. Mark a second small arc 5cm from the corner for the centre hole, then cut through all layers. Fold the circle in half and cut along one fold for the opening.
Can I make a tree skirt without sewing?
Yes. Cut a circle from fleece, which does not fray, with a centre hole and an opening, and fringe the edge with scissors. For a thicker skirt, knot the fringe of two fleece circles together, as for the no-sew blanket in our guide to the best fabric for a blanket. You can also glue a ribbon or trim to the edge of felt with fabric glue.
Is a tree skirt hard to sew?
No. A lined tree skirt is one long seam round a circle, with some clipping and pressing. It is a good beginner project, and takes about two to three hours. The patchwork version takes an evening longer because of the eight wedge seams. For more ideas for the weeks ahead, see our Christmas sewing plan.